Thursday, September 9, 2010

Ruffle Butt Tutorial

This tutorial is good for adding ruffles to anything really, but in this case, I was adding ruffles to a diaper I was sewing. It would look really cute on the butt of a onsie, too!

Take your ribbon and cut it to be almost twice as wide as the area you're covering.
I used 5 strips of ribbon, all the same length.
Heat the ends of the ribbon to seal them using a lighter.
Using a loose stitch, sew right down the middle of the ribbon. When you cut your thread, leave about an inch at the end. 
Pull the bottom piece of thread while pulling the ribbon in the opposite direction. This will make the ribbon scrunch up. Do this for all 5 pieces of ribbon, trying to make them all about the same length. 
Pin your ribbon to the butt of the onsie. 
You'll want to switch your machine to a tighter stitch for sewing on the ribbon.
Sew on each piece of ruffled ribbon, right on tip of the original stitch. You'll need to lift up the foot of the machine to straighten the ruffle every few centimeters. 
Trim your spare strings, and you're done!

9 comments:

  1. Those are so cute! I love the shiny pink ribbon. It looks so adorable! If only they looked right on boys! *sigh*

    ReplyDelete
  2. OMG a ruffle butt diaper, I love it!

    ReplyDelete
  3. I just LOVE little ruffle butts! They are so adorable! Thanks for sharing it on Thrilling Thursday @ Paisley Passions.

    ReplyDelete
  4. I'm all about ruffles and it's never dawned on my to use ribbon - perfect!!

    ReplyDelete
  5. It makes me want to have another little girl !!

    Caroline
    http://ateliercaroline.blogspot.com/

    ReplyDelete
  6. Precious! And I like easy a lot!

    ReplyDelete
  7. So cute!! :) Your project jumped out at me on Tatertots and Jello.

    ReplyDelete